RL Stephens Tool, 2003. All Rights Reserved.
Site Designed and Maintained by:
SPOON FROG graphics
MACHINE TOOL PROBES
Inspection Probes for Machine Centers - MP700
1717 North Raymond Avenue Anaheim, California 92801
Toll Free: 1 - 800 - 826 - 5133
Local Phone: 714 - 879 - 6637 Fax: 714 - 879 - 0911
The MP700 is an optical transmission part probing system for
use on machining centers. The MP700 is specifically designed
to deliver high-accuracy CMM type probe performance. The
MP700 uses strain gage sensors and an internal
microprocessor to provide a solid state sensor mechanism with
unprecedented life and reliability. Low trigger force and
consistent pre-travel results in high accuracy with long styli.

The MP700 is available with either 35 degree or 70 degree
output. An M code must be supplied to turn the probe on. An
internal timer or M code is used to turn the probe off.
MP700 retrofit kit
Includes:
MP700 probe with 70 degree OMP
OMM
OMM mounting bracket
MI12 interface
50 mm and 100 mm carbon fiber styli
Sealtite conduit
9 V alkaline battery
TK1 tool kit
Renishaw Inspection software
Inatallation and training
A shank (tool holder) is not included in this kit.

Part number MP700-NS-S
MP700 probe
Includes:
MP700 probe
Adjusting plate
9 V alkaline battery
Tool kit
Part number: A-2107-0035 (35 degree)
Part number: A-2107-0070 (70 degree)
MP700 probe module
Part number: A-2108-0001
MP700 OMP only
Part number: A-2107-0036 (35 degree)
Part number: A-2107-0071 (70 degree)
MP700 hardware only kit
Includes:
MP700 probe with 70 degree OMP
OMM
OMM mounting bracket
MI12 interface
50 mm and 100 mm carbon fiber styli
Sealtite conduit
9 V alkaline battery
TK1 tool kit
A shank (tool holder) is not included in this kit.

Part number MP700-NS-KIT
OMM optical receiver
Part number: A-2033-0576
OMM mounting bracket
Part number: A-2033-0830
MI12 interface
Part number: A-2075-0142
Sealtite conduit
Part number: SEALTITE, 7455
1/4 in conduit, 5 ft long. Includes one fitting.
Sense directions
Stylus overtravel
Stylus trigger force (factory set using 50 mm stylus)
+ and - X, + and - Y. + Z
X and Y: + and - 16.5 degrees
Z: 11 mm (0.43 in)
Z: 15 gf
X and Y: 2 gf
Undirectional repeatablility (max 2 sigma value)
0.00001 in